TolberSeal
A High Performance Inorganic Corrosion Inhibitor for Aluminum Alloys
 Coating thickness is less than 2 microns Does not effect dimensional tolerances Retains total electrical and heat conductance Will not chip, flake, or peel Accomodates temperatures from -80°F to +750°F Meets Ford Motor Company Specifications ESE-M2P128A Meets GM-4350M-B168 Unaffected by brake or engine fluids Can be applied before or after most required impregnation processes |
| TolberSeal has been Salt Spray tested according to ASTM-B-117 | |
| Cast Aluminum (depending on alloy) | 336 hours |
| Automotive | |
| 319 alloy | 250 hours |
| 356 alloy | 336 hours |
| Wrought Aluminum (rolled, sheet, bar) | |
| 6061 alloy | 1332 hours |
| 2024 alloy | 1500 hours |
| INSTRUCTIONS |
2. After the Chromate Conversion Process, dip for 30-40 seconds in TOLBERSEAL/water solution. 3. Immediately after 30-40 second dip, rinse in clean water for 30-40 seconds. 4. Allow part to age for 24 hours after rinse. * Ageing times for TOLBERSEAL are consistent with the ageing times of most Chromate Conversion Operations. |
PRECAUTIONARY INFORMATION
CONTAINS VOLATILE SOLVENTS -- Keep away from sparks and open flame. Store at temperatures above 32°F and below 105°F. Keep containers closed when not in use. Maintain adequate ventilation in working area. Wear approved respirators and protective clothing when working in confined areas. Avoid repeated breathing of concentrated vapors. Prolonged contact of liquid material with skin may be irritating. If material comes in contact with skin, wash skin surface thoroughly with soap and water. In case of eye contact, flush eyes thoroughly for 15 minutes with water and consult a physician. REFER TO MATERIAL SAFETY DATA SHEET FOR ADDITIONAL WARNINGS AND INFORMATION.
WARRANTY DISCLAIMER
Based upon Seller's experience, the information contained herein is believed to be reliable. Seller requests that Purchasers and users inspect and test Seller's products as to contents and suitability for a particular purpose. Seller disclaims any express warranties and nothing contained herein shall constitute any warranty, whether express or implied, and Seller hereby DISCLAIMS ALL WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Additionally, Seller makes no warranties concerning the compliance of products with any state, local, or federal laws or regulations and Purchaser assumes full responsibility for complying with such laws, regulations, codes and requirements. Seller makes no warranty concerning and does not assume in this or any other document any obligation or liability in connection with patent infringement suits brought against Purchaser, user and/or Seller with respect to Seller's products. The EXCLUSIVE REMEDY for all proven claims whether through negligence, strict liability, tort or otherwise is limited to an amount equal to the price of the particular products or services giving rise to the liability, or, at the election of the Seller, the replacement of the product in question. In no event shall Seller be liable to Purchaser for any incidental, consequential, indirect, or special damages, including without limitation, lost revenues or profits, even if Seller was advised of the possibility of such lost revenues or profits (subject to state by state application of Mag-Moss [16CFR701.3]).