T-100 Plastisol Primer

Formulated to achieve optimum adhesion under a wide range of application conditions when used in conjunction with MICCRO PLASTISOLS

T-100 is a clear primer adhesive formulated to achieve optimum adhesion under a wide range of application conditions when used in conjunction with PLASTISOL. In addition to being an excellent general purpose primer, it is especially resistant to hot alkaline solutions.

T-100 has been formulated to comply with the solvent requirements of Rule 66 of the Los Angeles Air Pollution Control District and Regulation 3 of the San Francisco BayAreaAir Pollution Control District.

CHARACTERISTICS

Color: Clear to pale yellow
Viscosity: 31 sec. #1 Zahn
Solids: 16%bywt.
Flashpoint: 43_F
Coverage: 380 sq. ft./gal. 0.3 mils
Wt./gal: 7.1 Ibs.


APPLICATION PROCEDURE

  1. Clean metal. For best adhesion metal must be physically and chemically clean. Sandblasting with clean sand or pickling and degreasing are satisfactory.
  2. Apply primer by dipping, brushing or spraying. Air dry for 15 min utes and bake at 360_ to 400F for 15 to 45 minutes, depending upon metal mass and oven efficiency.
  3. While metal is hot, dip into the PLASTISOL and leave until the desired coating is formed. The thickness film is determined by the amount of heat in the metal and length of time in the PLASTISOL.
  4. Evaporated solvent should be replaced with T-100 primer reducer only.

PRECAUTIONARY INFORMATION

T-100 and T-200 PRIMERS CONTAIN VOLATILE SOLVENTS: Keep away from sparks and open flame. Store at temperatures above 32_ F and below 105_ F. Keep containers closed when not in use. Maintain adequate ventilation in working area. Wear approved respirators and protective clothing when working in confined areas. Avoid repeated breathing of concentrated vapors. Prolonged contact of liquid material with skin may be irritating. If material comes in contact with skin, wash skin surface thoroughly with soap and water. In case of eye contact, flush eyes thoroughly for 15 minutes with water and consult a physician.

WARRANTY DISCLAIMER

Based upon Seller's experience, the information contained herein is believed to be reliable. Seller requests that Purchasers and users inspect and test Seller's products as to contents and suitability for a particular purpose. Seller disclaims any express warranties and nothing contained herein shall constitute any warranty, whether express or implied, and Seller hereby DISCLAIMS ALL WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Additionally, Seller makes no warranties concerning the compliance of products with any state, local, or federal laws or regulations and Purchaser assumes full responsibility for complying with such laws, regulations, codes and requirements. Seller makes no warranty concerning and does not assume in this or any other document any obligation or liability in connection with patent infringement suits brought against Purchaser, user and/or Seller with respect to Seller's products. The EXCLUSIVE REMEDY for all proven claims whether through negligence, strict liability, tort or otherwise is limited to an amount equal to the price of the particular products or services giving rise to the liability, or, at the election of the Seller, the replacement of the product in question. In no event shall Seller be liable to Purchaser for any incidental, consequential, indirect, or special damages, including without limitation, lost revenues or profits, even if Seller was advised of the possibility of such lost revenues or profits (subject to state by state application of Mag-Moss [16CFR701.3]).