MICCROWax C-562
A Reusable Coating for Hard Chrome Plating
- MICCROWAX is a single-material wax for selective stop-off that is especially suited for masking on complicated parts and sharp edges.
- MICCROWAX will not crack, and may be readily melted for use by any common heating medium.
- MICCROWAX shows a remarkable degree of adhesion, even when used on flat surfaces. It requires no prime coat before application which means only one dip tank is necessary for the complete operation.
- MiCCROWAX hardens immediately after the part is dipped, thereby minimizing preparation time and speeding production of parts before plating.
- MICCROWAX can be reused without loss of its efficiency.
- MICCROWAX may be used in most plating cycles as long as cycle temperatures do not exceed the melting point of the wax.
- MICCROWAX may be used in the following types of plating: Hard Chrome Indium Copper Acid Lead Copper Pyro Silver
APPLICATION PROCEDURE
- MICCROWAX C-562 should be held at temperatures between 1 75_F. and 1 85_F. to attain a maximum thickness of coating for use in selective hard chromium plating. The parts to be stopped-off should be cleaned of all dirt, grease, etc. Immerse in MICCROWAX for a few moments to raise the temperature of the part and withdraw. Two or three successive, fast dips will provide a heavy coating that will withstand any hard chromium cycle. The portion to be plated can be bared with a knife and the surface cleaned with naphtha before plating.
MICCROWAX C-562 comes in 10 lb. cakes, 5 cakes per carton. 7.8# gal. when melted. 51 # per cu. ft. when melted.
PRECAUTIONARY INFORMATION
CONTAINS VOLATILE SOLVENTS -- Keep away from sparks and open flame. Store at temperatures above 32°F and below 105°F. Keep containers closed when not in use. Maintain adequate ventilation in working area. Wear approved respirators and protective clothing when working in confined areas. Avoid repeated breathing of concentrated vapors. Prolonged contact of liquid material with skin may be irritating. If material comes in contact with skin, wash skin surface thoroughly with soap and water. In case of eye contact, flush eyes thoroughly for 15 minutes with water and consult a physician. REFER TO MATERIAL SAFETY DATA SHEET FOR ADDITIONAL WARNINGS AND INFORMATION.
WARRANTY DISCLAIMER
Based upon Seller's experience, the information contained herein is believed to be reliable. Seller requests that Purchasers and users inspect and test Seller's products as to contents and suitability for a particular purpose. Seller disclaims any express warranties and nothing contained herein shall constitute any warranty, whether express or implied, and Seller hereby DISCLAIMS ALL WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Additionally, Seller makes no warranties concerning the compliance of products with any state, local, or federal laws or regulations and Purchaser assumes full responsibility for complying with such laws, regulations, codes and requirements. Seller makes no warranty concerning and does not assume in this or any other document any obligation or liability in connection with patent infringement suits brought against Purchaser, user and/or Seller with respect to Seller's products. The EXCLUSIVE REMEDY for all proven claims whether through negligence, strict liability, tort or otherwise is limited to an amount equal to the price of the particular products or services giving rise to the liability, or, at the election of the Seller, the replacement of the product in question. In no event shall Seller be liable to Purchaser for any incidental, consequential, indirect, or special damages, including without limitation, lost revenues or profits, even if Seller was advised of the possibility of such lost revenues or profits (subject to state by state application of Mag-Moss [16CFR701.3]).